Shopping Cart
No products
Prices are tax included
Track thicknesses Eibach 100x5 in 20 mm
165,75 € tax incl.
195,00 €
-15%
Direct factory!
Sold in pairs.
Thickness in mm (coating): 20 mm
total width by axles: 40 mm
Entraxe: 100x5
Moyeu Diameter (Alsage): 57 mm
Fastening thread: M14x1.5
Colori des cales : Aluminium
Screws included
With rim centerer
Fixing system: Double bolt
Screw mounting system
Type of system Eibach : 7
kit reference : S90-7-20-028
Example of compatible vehicles:
AUDI A1 (8X1) 05.10 -
AUDI A1 SPORTBACK (8XA) 09.11 -
SEAT IBIZA IV (6J5, 6P5) 03.08 -
SEAT IBIZA IV SPORTCOUPE (6J1, 6P1) 07.08 -
SEAT IBIZA IV ST (6J8, 6P8) 03.10 -
SKODA FABIA III (NJ3) 08.14 -
SKODA FABIA III KOMBI (NJ5) / STATION WAGON (NJ5) 10.14 -
VW POLO (6R, 6C) 06.09 -
VW POLO STUFENHECK / POLO SALOON 05.09 -
Be careful to take this technical information into account before ordering! In case of doubt, our team remains at your disposal to refine your research!
Technical Notes: The centre lid (scratch corkscrew) must be removed from the wheel holder and pushed onto the intertoise.
A question about compatibility, fixing your hold? Need to find the right visserie? Contact us
Informations sur le fabricant
Find all my useful tips :
- If you are looking for the compatibility of a shim, a set of Eibach suspension springs, or even to find a reference for your vehicle, I invite you to go to the Eibach search engine. Isolate the reference which is appropriate to you and communicate it to us, we will help you to find it on our Internet site: Eibach Online Catalogue.
- You are looking for Eibach fasteners for your wedges or your vehicle? Click here and activate the search engine to find the right reference: Search engine for Eibach fasteners.
- Find my tips in our FAQ, on how to measure a lowering or how to measure the thickness of a shim for your vehicle.
Additional note:
For users of Rumble Bars, threaded combos, short springs, or low suspensions, wheel chock mounting may be required. Spring lowering is always given on a standard chassis basis. If you have a sport chassis option, the lowering of this one will be deducted. The same goes for special equipment (4x4, leather, 3 doors, auto gearbox...etc...) the lowering can sometimes vary by a few millimeters because of the extra weight. The lowerings are never perfectly identical to the millimeter, no need to go looking for the detail with the caliper, of course.
Reminder: If your vehicle is equipped with wheel studs, measure the length of your studs before ordering. If you use thin wheel studs, the studs will protrude and prevent the installation of the rim. It will then be necessary to buy studs with a suitable length under the head because they are not supplied with the chocks.
Find our Antivols de roues, goujons longs, visseries de jantes in the dedicated section!
| Materials: | Aluminium |
| Filter the type of parts | Wheels: Wheels (all models combined) |
| Filter the type of parts | Wheels: DOUBLE bolts (20mm) |
| Thickness: | 20mm |
| Colors: | Aluminium |
| Wheel | Spacers |
| Options de roues | Double boulonnerie |
Related Products
