spring kit for SEAT Leon I

kit springs short ST Suspensions for SEAT Leon (1M) 2 wheel drive 1.8, 1.9TDi

Years : 09/99-08/05

Compatible vehicle power (in kW): 66-165

Maximum permissible weight on the front axle (in Kg): 931-980

Maximum permissible weight on the rear axle (in Kg): -985

Front/rear reduction possible (in mm): 50/40

Technical note to be taken into account before ordering:

For 50mm diameter models, it is highly recommended to replace the original stab bar to avoid contact with the right-sided wheel shaft, use the stab bar. 66550008 (to be ordered separately). (91)

With a 45mm discount on the front axle, it is advisable to change the stab bar. See our REF kit. 68550000 (without Xenon light) or 6855005 (with Xenon light)

Note:

shock absorbers and springs ST Suspensions are supplied in sufficient quantity to equip the vehicle. They mount in place of the original suspension, without modification. If, for example, you only have springs in the back, it will also be the case with these kits ST Suspensions. Think about equipping you with original cups for mounting. The kits ST Suspensions are delivered naked (device cartridges and/or/with springs if applicable), unless an accessory essential to lowering is required.

The damper cartridges are sold individually! So you will have to order at least two to equip a axle.

WARNING, compatible powers are expressed in kW (Kilowatts). To know the correspondence in cv, you must convert this data (1kW = 1.36cv). Online converters are also available.

ST Suspensions is a brand KW, and the products of this brand are made by KW.

We remain at your disposal using the contact form for any other information.